1-6-2018 THIS BOARD IS IN STOCK. THE INDIVIDUAL BOARDS ARE AVAILABLE!
See the Mechanical Drawing Link on main page for dimensions on the panel and each board.
This is a 4 board panel, consisting of a 0.5 mm TSSOP, a 0.65 mm TSSOP, and, Tiny Chip 2.
It now has the Proto-Chip JR. Protoboard. This and the Tiny Chip2 are the best selling Protoboards I have. The PC JR. replaces the 0.8 mm board on the 1st original panel. It makes a decent discrete protoboard. Treat these like a protoboard, cut and hack these guys, to fit into your applications, and build a more complete circuit at the same time!
Cut the traces!!, to make the circuits after doing a LAYOUT FIRST... they are protoboards, figure out ways to use them! I know, they didn't teach you in school.......so read the soldering article I have for a start! Think around the box, inside and outside! Burn and Learn! (Hopefully no burning!) Disney used IMAGINEERS...what are you made of? DIY means show off YOUR work...
Even a crappy built circuit on a pretty board will help out with nice solder points, and IC's that look professionally mounted! (See the Article...? yet?)
Each individual board has ground plane on back side, soldermask on top and bottom, power/ground traces on board edges.
See the TSSP1, TSSP2, TSSP3, PCJR and TC2 board page links, for more individual board info, and TSSOP Panel Mech. Drawing.
Each board has at least 3 different patterns for IC's, and SMD Proto-Chip wiring pads for 1206 to 0603 parts, SOT's, and wiring circuits from top and back sides! The Panel will snap apart for individual boards, or leave it a panel. Or snap it in half....its a protoboard, remember?
Just because it looks pretty....there's an ugly protoboard under that soldermask! Make something out of it! Research, Experiment, Adapt and Overcome! And then, build thousands......!
It all starts with - A Prototype! SO... REWIRE IT!!!
GIT R' DUN!!!