TSSOP Panel of 4 different Pitch parts.
It has 1.75
You have just found THE BEST Surface Mount Device Designers BreadBoard Site!

Proto-Chip!

THE NEW PROTO-CHIP Family of SMD BreadBoards ARE Now Available!!

SEE the QFP and TSSOP-SOIC Panels!
1.5" and 1.75" square SMD protoboards, NOT Just Adapters!

SOIC-Wide & Narrow, SSOP, TSOP32, SC70-6, SOP32, SOT23, 89, 143, 223, 0603 to 1206!!

Ground planes, Power traces, SMD wire pads and micropads!

I now have a Proto-Chip Index page, with all my products on 1 page, not all pix yet. APRIL 2005. Summer is not here yet, but the SMD board wars are just getting started! Get your SMD circuits built up on the BEST SMD Breadboards available! See the Soldering article and Capacitors info page, HUGE Links pages for electronics, and Test Equipment, Radios, restoration, etc. More links coming soon.

THE BEST of Both Worlds, Colliding!
Where else, but THE BEST SMD Prototyping Site on the Net, if not the globe!

Home Page
Proto-Chip n' DIP
TSSOP-PLCC
ORDER Proto-Chip PCB Here
Proto-PLCC
PCB DESIGN Services
Technicial Articles
Links Page
Frequently Asked Questions
Contact Us Page
Proto-Chip n' DIP 2
Customer Photo Page
Proto-Chip & Chip n' DIP 2
Tiny Chip
Proto-SSOP
QFP 0.5 mm
QFP 0.8 mm
4 PCB Special
TSSOP 0.5 mm
TSSOP 0.65 mm
SSOP 0.8 mm
10 K Ohm 1.4 W 5% Resistor
TSSOP PNL
Tinychip2
Proto-Chip Index
18K
820-2W
QFP PANEL
Proto-Chip JR
QFP 0.8 mm

THIS BOARD IS SOLD OUT !

QFP 0.8 mm pitch 24 pin to 52 pin SMD breadboard. 0.8 mm pitch, can fit many popular chips. Ground plane on back. Power and ground traces, vias to ground plane, solder mask on back.

Proto-Chip Thru-Hole pads for wiring and components on both sides. Micro-Pads for wiring, or SOT23 or 0603 and smaller parts. Trim the pads not needed to fit QFP part on board, and can put SMD ribbon header on pads from chip.

Put suporting parts on board like clocks or regulators.

Try using SMD headers, that have "L" shape bends at the end, or, the regular 0.1" thru-hole ones. Just tack one end on the pad/hole, then align the rest of them and solder the other end down, and give it a good bit of solder to hold it on the pad.

That will be your socket/board interface below the board, or the test/wire points on top side... Or you can try using it for the 0.8 mm pitch SOIC's? fitted across the lead traces....? Cut it up to use for connectors? Reworking modules? What can you think of using it for?

Thank You!
$5.95 $5.25
Related Items

Here are some products that may also be of interest to you:

Proto-Chip JR
Proto-Chip PCB
Proto-PLCC
Tinychip2
TSSOP 0.5 mm
TSSOP 0.65 mm
TSSP2
10 K Ohm 1.4 W 5% Resistor
18K
820-2W